~TABASCO~
RIDE ON ADV is what I do !
Founding Member
2011 Site Supporter
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Vendor
There are two vent lines going to the front left of your engine. They are tucked in a -C- shaped holder. Pull them out of the -C- shaped holder and push both up toward the bottom of the tank a little... With this being done you should be able to lift the tank almost vertical 10"+... With the tank almost straight up you can work on this stuff easy...... Just loosen the rear bolt a little so it doesn't bind on the rubber grommet.. No need to take out.. Take off all those hoses and such. Do your adjustments, sync it, and then put back on the left stock hose and the right nipple.... done..... ::008::ColoRider said:You must have a LOT smaller hands and/or longer fingers than I to be able to access the connections with the "tank in place"!!!! Even with the front and rear hardware removed, I can only raise the tank about 1 1/2 to 2" and still have a hard time reaching the fittings.
That said, I'm about to the point where I think I will remove my pigtails. Too many horror stories popping up here about problems (including mine)!
::010::