I was doing my install last night, using pretty much the same exact method that Mellow posted above. I had it all ready to epoxy it in place and found out that my tube of 2 part plastic epoxy was all dried up. :'(
So, hopefully some time today I can run to the store and get some more. I should have it all wrapped up pretty quickly then and will try to get a good pic of the install. But basically all it is, is what Mellow had in his pics with a touch of epoxy to hold the bottom half of the VC to the throttle housing. Only caution is to be sure not to get any epoxy around the pivot point of the VC, and to make sure you only epoxy on one side of the throttle housing. In other words don't go over the seam in the housing, it's 2 pieces and you dont want to fuse the 2 halves together!
So, hopefully some time today I can run to the store and get some more. I should have it all wrapped up pretty quickly then and will try to get a good pic of the install. But basically all it is, is what Mellow had in his pics with a touch of epoxy to hold the bottom half of the VC to the throttle housing. Only caution is to be sure not to get any epoxy around the pivot point of the VC, and to make sure you only epoxy on one side of the throttle housing. In other words don't go over the seam in the housing, it's 2 pieces and you dont want to fuse the 2 halves together!