NoMorBills
New Member
After looking at some aftermarket companys and what they wanted for splash shields. I decided I could put some old plates to good use.
This all took about 30 minutes and I did have to slip them in from the top. So I had to pull the seat mount and the tank mount. Very simple!
Yes the brake resevoir is going to take a little more time to get to. But possible a small hole to run a screw driver thru will take care of that.
I did extend the right side with another piece of plate. Next I will get some flat stock alluminium and make some permanant ones.
This all took about 30 minutes and I did have to slip them in from the top. So I had to pull the seat mount and the tank mount. Very simple!
Yes the brake resevoir is going to take a little more time to get to. But possible a small hole to run a screw driver thru will take care of that.
I did extend the right side with another piece of plate. Next I will get some flat stock alluminium and make some permanant ones.