Final drive guard /shield

[midlife]

Hi Folks,



Picked up one of these second hand without any fittings. Can any one tell me what type of fitting is required under the rear spindle/axle please? The other 2 fixing points are obvious.
Many thanks in advance
Rob

 

[silvergoose]

Can you contact the manufacturer? Look on line you may find some photos showing the unit mounted.

Good Luck

 

[~TABASCO~]

There is a special two way bolt/nut that is installed in the drain plug I believe. Then you instal the guard and put a normal bolt though the guard and into the thing I described first. And at the front- uses a big zip tie.

 

[silvergoose]

With all due respect, I do not think a Large zip tie is part of the mounting package. The part about attaching to the drain plug is also incorrect.

Please, review, on you tube the video, of how to mount the guard. You will have to have a mount plate, attached to the axle bolt, along with attachments to the two lower bolts in the drive shaft to final drive housing.

Good Luck