I was looking for some adjustable pegs for my T12 to lower them a touch to take the strain out of old knees. I ran across the SW Motech Evo pegs, but wasn't thrilled with the $209 price tag. As I was going through the website, they had a sale on some that according to their website wouldn't fit. As a former Yamaha dealer, I cross checked all of the model numbers and all of them showed to use the same part number so I went ahead and ordered a set. Their website showed them to fit a type "DP07" and would not fit a "DP04". I have no clue what the difference is, but when I received them the only difference I could find was the diameter of the clevis pin. The package showed it also fit a XT600Z Tenere, so I looked up the part number for that pin and it was 10mm in diam eter where the US spec T12 is 8mm. They mounted fine with the 8mm pin from my T12, but I went ahead and ordered a package of 10mm x 40mm pins from Amazon and will drill the clevis on the bike out 2mm when they come in.
They have these pegs on sale for $70 and it says "limited stock"! I got them mounted and they work exceptionally well by allowing the peg to raise and lower as well as move for and aft on the eccentric built in to the peg.
This is a great deal for those looking while their supply lasts..... This is the link to the pegs...... https://sw-motech.us/bike/YAMAHA/XT1200ZE/2016/DP07/products/ergonomics/footrests/
They have these pegs on sale for $70 and it says "limited stock"! I got them mounted and they work exceptionally well by allowing the peg to raise and lower as well as move for and aft on the eccentric built in to the peg.
This is a great deal for those looking while their supply lasts..... This is the link to the pegs...... https://sw-motech.us/bike/YAMAHA/XT1200ZE/2016/DP07/products/ergonomics/footrests/