As I mentioned in another post I designed switches panel for operating auxiliary light.
The body is prepared for APEM 9433 NCD switches:
http://www.apem.com/files/apem/brochures/switch-pushbutton-9400-9600-ENG.pdf
with sealing bots U1403 :
http://www.apem.com/files/apem/brochures/switch-sealing-boots-ENG.pdf
The switch is momentary closed, therefore to operate the lights an additional module is required.
I used an electronics kit available in my country, AVT :
https://sklep.avt.pl/avt1916.html
…. Yes, only in polish, but a movie explains its functions, I hope…
The module contains four channels/relays, three of them are used. The first ones turns on the aux lights independently of main lights. The second ones gives "stand by" mode. The aux lights come on when the high beam of the headlight is switched on. The third ones is used for switching off ( is used, but its relay is not connected to any signal).
These relays are not connected directly to the aux lights. They give only steering signal for the main relay.
I can prepare and publish an electric diagram if there is necessity.
The body of the panel is finally 3D printed and other preparations are required (drilling, finishing of surface, bonding metal insert for screws... easy work).
I can send .stl file (used by 3D printers) for interested.
Aaaa, the other two switches are used for LCD panel (temperature, fuel consumptions, ODO…)
The body is prepared for APEM 9433 NCD switches:
http://www.apem.com/files/apem/brochures/switch-pushbutton-9400-9600-ENG.pdf
with sealing bots U1403 :
http://www.apem.com/files/apem/brochures/switch-sealing-boots-ENG.pdf
The switch is momentary closed, therefore to operate the lights an additional module is required.
I used an electronics kit available in my country, AVT :
https://sklep.avt.pl/avt1916.html
…. Yes, only in polish, but a movie explains its functions, I hope…
The module contains four channels/relays, three of them are used. The first ones turns on the aux lights independently of main lights. The second ones gives "stand by" mode. The aux lights come on when the high beam of the headlight is switched on. The third ones is used for switching off ( is used, but its relay is not connected to any signal).
These relays are not connected directly to the aux lights. They give only steering signal for the main relay.
I can prepare and publish an electric diagram if there is necessity.
The body of the panel is finally 3D printed and other preparations are required (drilling, finishing of surface, bonding metal insert for screws... easy work).
I can send .stl file (used by 3D printers) for interested.
Aaaa, the other two switches are used for LCD panel (temperature, fuel consumptions, ODO…)
Attachments
-
4.6 KB Views: 34
-
35.6 KB Views: 71
-
28 KB Views: 59
-
36.7 KB Views: 71
-
30.8 KB Views: 56
-
35.9 KB Views: 56
-
45.7 KB Views: 64
-
61.2 KB Views: 90