Search results

OEM screen OEM Exhaust All taken off my 2011 ST The screen is in excellent condition. It has two holes near the top edge where I experimented with a perspex strip to find the perfect screen height. The exhaust is in good condition but will require a new bolt on the clamp. I'm located in...

This rack has been on my ST 2011 for 4 years. All fittings are present, but the brackets that remain on the bike could do with freshening up. Givi monokey mounts attached but these can be replaced with other kits. Its in the UK, South Yorkshire. £80 +post/package. Be nice for a local pickup.

Because my instrument console on my 2011 fell foul of the 23K mile glitch I lost my odometer, trip, time set, diag functions. The things I miss most are the odometer and trip so I'm going to fit a second unit. I've looked at the bicycle computers and think I need more permanency and robustness...

I'll be out and about around North Derbyshire today. Might get a sun tan !!!

My rear brake disk is ready to renew so I've been searching for a replacement. The choice appears a bit limited in the UK, but I did find a galfer. When I extended my search for the Galfer I found a site that said the XT1200 disk would also fit an FJR1300. Searching for rear disks for an...

Anyone off to the bike show ? I was thinking of having a drive down.

I've ridden my bike with lowering links and the yokes lowered 13 mm. I want to go a couple of millimetres more as the bike is a little slow into corners. The forks taper at this point so I was wondering if anyone had got around the clamp problems either with spacers or magic ! I'm wanting to...

Yesterday morning on the M18 Southbound between A1M and Maltby, I saw a well dressed grey Tenere. I'm on that stretch of motorway quite often , but prefer the backwacs at busy times. Looking through the rear mirrors I could just make out the headlights against the mirriad of car headlights...

Does anyone have the oil seal specifications ie internal/external diameter, depth and type for the final drive? Particularly the seal on the drive shaft. I have an oil seal supplier who is easier to access than a Yam dealer. I'm suffering from an oil leak on spirited rides, steadier riding...

I tried to reset my trip meter after filling the tank. Left button press - no change, no cycle through the trips to the odometer. It looks like a failed switch. Has anyone had experience of servicing/replacing these switches?

I have a UK stock Tenere approaching 24000 miles. No engine issues til now. This started to happen the other day after a 30 mile run to a butty bar. After sitting in the heat of the Sun for an hour , I fired the bike up and set off. The engine surged for a fraction of a second at just over...

Has anybody made use of the sapce under the rear seat luggage rack? I need space to fit the starcom1 intercom. With plugs and cables it needs a lot of space. The area under the rack is large but doesn't look water tight. I'm thinking of cutting access into the top and fixing a cover plate...

I've been lurking for a few months and thought I'd now join the ranks. My previous was a 2005 US spec FJR. After 55000 flawless miles and an agonising decision after a sit on a friends Tenere I decided to go for the Tenere. I've had my black Tenere from the beginning of August. Due to the...