Search results

When I had my tires replaced, they didnt use loctite and the screw came out. The plastic tab that holds the sensor in place was damaged when it hit the rotating wheel. I was able to fab a large washer with a notch to hold it in place. The sensor is still functioning.

Hello, I need to replace my front ABS sensor and need tips from anyone that has done it. Im assuming the connector is somewhere under the tank. Once i replace the sensor, is there any thing that I need to do to the ABS system? Thanks Al

Here is a picture of the damaged sensor screw hole(sensor is still functioning). 2nd image is my temporary fix. It is completely stable.

Does anyone know the bolt size for the front abs sensor? the Sensor is intact, but the screw opening is broken in half. While i order the replacement abs cable. i want to use a screw and washer to hold the current broken one in place. Surprisingly, duct tape held it in place until i go home...

Hello Guys, i did the original inspection on the road with the bike still muddy, but after getting home and doing a much thorough inspection, it looks like the abs sensor screw had come out and the sensor i guess was in the slot but not fully. When i re-checked it, it had come out fully and...

Hello and thanks in advance for any input. I am a farely new owner of a 2013 ST and am in the middle of a week long trip. After riding on a 10 mile Muddy gravel road my ABS and engine light came on. The TCS light will also come on after a minute or so after riding. Ive tried cycling the key...

Here is my setup. ShipRock, NM

thankfully, Im not having that issue.

I finally got around to finishing my Fuse block, Dash fill and switches. My dash now has a double usb plug, driving lights switch, fog light switch, and a usb plug switch. i Put a switch for a usb plug that i mounted inside my top box, just because i want to turn it off when im not using it...

I got my dash infill set with USB/USB-C plug, Switch for driving lights(white), Fog Lights (Yellow), for USB plugs in my top box(Red).. I am trying to decide where to install my aux. fuse block. Im steering towards under the upper right cowling. Im looking for advice on installing the panel...

I have a 2013 that i would like to add a throttle lock. I have stock bars with Yamaha hand guards. Does anyone have experience adding a throttle lock? I've used Kaoko on other bikes in the past. Thanks Al

Thanks guys.

Just recovered from crashing my GSA (3years ago). When i had my GS, i always said that ST was going to be my next bike. I couldnt pass up this deal on a '13. I wanted a '14 for the cruise control but this is still a nice bike with only 30k miles on it. Since my accident was caused by the...

Hello, What size did you end up going with? I'm still trying to decide wether to go with 2-37s or a Left 37 and a right 48?

Here is my gear i packed for a 2 week trip up to Alaska from California, minus clothes and Food.

Hello, After crashing my GSA 2.5 years ago. I'm ready to get back on the saddle possibly on a 2014 ST. I became a member of this forum to learn about these bikes..I've aways liked the look when they came out and now is a good opportunity to get one. AL