Recent content by yamabob

Do you need new caps or have to modify the stock ones?

I just did a trip from Chicago to North Carolina and lost both headlights on my first day. My buddy said he saw me with only one headlight working and then none. Luckily it was daytime and I have extra aftermarket lights. First check was if I had power to the bulb connections, no power. Once we...

I know this is an old thread, but I found the fix for my Fault code 19 issue. I cleaned the ignition switch with electrical cleaner and once dry, lubed it with PTFE spray. This has solved the code 19 problem. If it happens again, I'll probably replace the ignition switch, but so far so good. The...

I used the Skene with my Rigid light bar for a number of years. Skene says it's not compatible, but it finally failed. I loved it when it did work though. Had it set "on" for 20% light output and 100% when you hit the high beams. Once the Skene controller failed, I just set it up to an on/off...

I'll check the starter relay and go from there. It still needs the recall ^ too. Thanks!

Yes, it has a recall for some throttle wire that could make the bike not come back to idle after twisting the throttle. I haven't had the traditional "no start" issue that keeps popping up for many people though. And it throws the code too. I planned on having the recall done when they check...

Looking for some help. Been having an inconsistent problem. I shut the bike off at a gas station, go to start it and it cranks but won't fire. Turn the key off, reset everything and try again, then it throws a code 19 (side stand). Cycle through the on/off routine a couple times and it fires up...

Maybe the side stand switch is shorting out momentarily?

Oxford adventure grips. The adventure ones are slightly longer than the regular ones. They work great. No issues.

I have a Seth Laam and love it.

Just add a couple washers to move the handles out a bit. I've been running it this way for a few years. Sent from my iPad using Tapatalk

Love the winglets. Sent from my iPhone using Tapatalk

I'm running a 6" Rigid light bar with a Skene controller on my 2013. No issues! When the low beams are on, it's at 20%. High beams on, it's at 100%. Not sure what the compatibility problem is. I've had this set up since I bought the bike in 2013.

I have the ATV Mid bars with the Tusk 1" riser blocks. No issues. Cables and hoses are fine.

Try the Warn mounts. I have them mounted on my alt rider bars with Rigid lights. No issues. Sent from my iPhone using Tapatalk