Recent content by Snooze

I have recently purchased The Vstream Touring which has become available for the 2014 T. I have found using the stock, a mid size parabellum and now the Vstream, side winds are almost impossible to stop wind buffeting. I sometimes ride in Wyoming and the wind is always terrible there. Winds in...

This a pic of my Happy Trails setup but you might find it too wide. From outer edge to outer edge of the boxes is a little over 36".

I have had the helmet for a little over three months. One thing I like is the clear visor gives me a bigger field of vision that my other full face helmet. I was afraid the detachable visor might be bad in the wind. Around here in Colorado it doesn't seem to be a problem. I did take it off when...

As a matter of fact, I did own a KLR

I am very cheap. I chose a low cost method of attaching my GoPro to the farkle bar. I got a small piece of clear plastic and some pipe clamps. I could never seem to get the clamps tight enough so I drilled two small set screws into the bar. Now everything is nice and tight. The only problem is...

Thank you very much for the information. The three prong connector is supposed to be on all models so I will have to look a little closer and hopefully find it. Also, I'm using the Centec fuse box so it should be easy to hook up. (famous last words)

Does anyone know what these electrical connectors are for? I was looking for a place to connect to a switched power source on a 2014. The threads I have read all concerned pre 2014. I expected to find the same type of three and four prong connectors as on the earlier models but there are no...

The station near my house in Denver, Colorado is down to $1.34 ::015::

TreeMuncher, You said you have been using Rain X for years on your windshield and visor with no problems. I just picked up a small bottle and didn't pay much attention to directions. Once at home the box says to not use it on plastics, don't let it touch painted surfaces or surfaces treated with...

Gloves have been the biggest problem for me when riding in the rain. I use disposable rubber gloves on the inside of my gloves. The gloves are wet but the hands are dry. A friend of mine found some black dishwashing gloves that were big enough to fit over his gloves. Check at the supermarket or...

Hey WestBarn1 I see you live in Norwich. I lived in Lakenheath as a kid. Great place.

Wasn't me but I was there in June. That is my favorite road in the US.

You will need a 12mm hex head socket to remove the bar ends on a 2014. I had to order one from NAPA because most stores only carry up to 10mm. Once you have the right tool the job is very easy.

The cooling vest is the way to go. Before I head out I soak the vest to get it really wet and then put it in a ziplock bag. When I want to use it I just take it out of the bag and wring out the excess water and I'm good to go. I also have a neck wrap that works pretty good.

I just installed my Vizitec Supabrake today and with all of the help on this forum, installation was pretty darn easy. I used profile #2 and hope to get feedback from friends real soon.