11 lbs.I wonder what they are rated for. I sent them those pictures. I've had it loaded pretty good before. But was on the road only. These Ms. road are pretty damn lumpy though.
I am searching for a rear rack and leery of the AltRiders based on breaks. Considering the SW Motech currently.11 lbs.
Why on earth would anyone buy a rack that is rated for 11lbs.
I can stand on my nordic rack (literally)
Sent from my iPhone using Tapatalk
I am searching for a rear rack and leery of the AltRiders based on breaks. Considering the SW Motech currently.
Are you able to use the Nomadic rack without removing passenger grab rails?
No removal of the factory rails or pannier mounts. I added this when my factory one broke. Its super thick aluminum.I am searching for a rear rack and leery of the AltRiders based on breaks. Considering the SW Motech currently.
Are you able to use the Nomadic rack without removing passenger grab rails?
Sell me one. PALto complement the above... #11
i did a mount check and lucky me i did all the measurements well ; this was the challenging part as tolerances were really at the 10th of mill...
I have used all the available 5 mounting points (yes there is an additional 5th hole hidden by a plastic cap just in case you didn't know) with 5 machined spacers (the two at back are 3 mm higher than front ones)
Those hold the bottom compartment (4.5 litres capacity); its back door (which later i covered in 3M carbon look) open/closes by 4 magnetized points at its four edges (20 Kg of pull...)
I did a satin finish to all the visible aluminium (i though initially to anodize... but man... that is VERY expensive...so i left the idea alone)
Here are some pics of the mount and the final result
View attachment 72374
View attachment 72380
View attachment 72376
View attachment 72377
View attachment 72378
View attachment 72379
You are a craftsmen, sir. That is B-E-A- UTIFUL!!!!!!!!!!!I did a satin finish to all the visible aluminium (i though initially to anodize... but man... that is VERY expensive...so i left the idea alone)
Here are some pics of the mount and the final result
Altrider frame is s givin it up wondering if it cann be weldedView attachment 56187View attachment 56186