I just installed a set of Shinko 705s and the front took a lot of weight. 3oz. I will admit the Dot was not placed correctly, well it was when I started to mount the tire but apparently it shifted so its about 6 inches off from the valve. I can't believe it would make that huge a difference. Maybe it does. I haven't ridden he bike yet so I have no idea if the balanced is correct other than on the static balancer. I also added an ounce of Dynabeads....
Just curious if anyone else has experience with the 705s.
On a side note I pulled the rear caliper to check the pads and they were almost ready to be replaced. However one of the slide pins came out hard and I noticed the threads seemed galled. I ordered a replacement pin as the caliper seems okay. Anyone see this issue? I assume it came from the factory like that as I have done all the work on the bike and that was the first time I unbolted the caliper. Basically the bike is sitting on the lift waiting on pads and the pin before she can get test ridden....
Just curious if anyone else has experience with the 705s.
On a side note I pulled the rear caliper to check the pads and they were almost ready to be replaced. However one of the slide pins came out hard and I noticed the threads seemed galled. I ordered a replacement pin as the caliper seems okay. Anyone see this issue? I assume it came from the factory like that as I have done all the work on the bike and that was the first time I unbolted the caliper. Basically the bike is sitting on the lift waiting on pads and the pin before she can get test ridden....