I finally took pictures today of what I have put on the ST. I have the Jesse ODYSSEY II cases that are 10" wide. With the first pictures you can see they don't stick out that far.
Looking at them from the back they do look big. In the Givi top case I have added admore LED lights that work as rear lights, turn singles and break lights.
I have upfront on the sides Altrider crash bars, right side panel comes off, Left side wont come off I can just loosen it up enough to lift the tank. On the bars I have Solstice Solo LEDs
Here are close up shots of the Altrider Joint cover
Here is the brake cover. Both are well designed but the instructions were a little hokey
.
Since the bike did not come with any helmet locks and I ride 2 up a lot I needed on on the bike. After much looking and trying to find a good place for it I found the license plate mount bracket bolt pattern fit perfectly on the 2 bolts for the passenger pegs.
.
In the cockpit so far I just have the switch for the LEDs, and Zumo mounted with the SW-Moto bracket and infront to keep the wind off I have a GIVI screen.
Looking at them from the back they do look big. In the Givi top case I have added admore LED lights that work as rear lights, turn singles and break lights.
I have upfront on the sides Altrider crash bars, right side panel comes off, Left side wont come off I can just loosen it up enough to lift the tank. On the bars I have Solstice Solo LEDs
Here are close up shots of the Altrider Joint cover
Here is the brake cover. Both are well designed but the instructions were a little hokey
Since the bike did not come with any helmet locks and I ride 2 up a lot I needed on on the bike. After much looking and trying to find a good place for it I found the license plate mount bracket bolt pattern fit perfectly on the 2 bolts for the passenger pegs.
In the cockpit so far I just have the switch for the LEDs, and Zumo mounted with the SW-Moto bracket and infront to keep the wind off I have a GIVI screen.