Rumbux question

Xclimation

Active Member
Joined
Aug 17, 2016
Messages
574
Location
Ft. Worth, Texas
I'm in the process of rehabbing a Rumbux setup I got for a good dealio. It had been in a wreck and I'm almost there as far as heating and bending goes.
My question: How far from the bottom of the bike is the skid plate. I'm talking the Aluminum plate that's underneath. Right now I'm showing between 1/8 and 1/4 of an inch. Supposed to be that close?
Thank You in Advance!
 

Don in Lodi

Well-Known Member
Founding Member
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Joined
Feb 1, 2011
Messages
5,296
Location
Lodi Kalifornia
I'm in the process of rehabbing a Rumbux setup I got for a good dealio. It had been in a wreck and I'm almost there as far as heating and bending goes.
My question: How far from the bottom of the bike is the skid plate. I'm talking the Aluminum plate that's underneath. Right now I'm showing between 1/8 and 1/4 of an inch. Supposed to be that close?
Thank You in Advance!
Ping Eric, he's our distributor for the Rumbux. Also a bump, maybe Eric will see...
 

EricV

Riding, farkling, riding...
2011 Site Supporter
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Joined
May 22, 2011
Messages
7,800
Location
Tupelo, MS
Just seeing this now. The aluminum plate is normally about 1/4" below the sump. So you're in the ballpark.
 
Top