I can't believe this, I had the recall done on my 2012 that was acting up last month (high/low idle) then did a 2,700 mile trip over six days with no issues at all. I just put on a new front tire Saturday and removed the non operating power outlet on the dash as I'm planning on replacing it with a UBS port. I went to start it to try out the new front tire and it just turns over. Hooked it back up to the battery tender and tried again Sunday and again just now. Battery is right at a year old and seems to turn over just fine. The fuel pump cycles when I turn on the key. However, when I let go of the starter button it cycles again and I don't remember it doing that before. But then again, it always started so that may be normal. I did move the top triple clamp around as I was adjusting the steering bearings and I did wash the bike when I got back from the trip. I can't remember if I started it since returning from the car wash three weeks ago.
I'm about to go out and check fuses and ignition switch wiring now but I wanted to run the across the group to see if anything jumps out, plus it helps me think through what has changes since the last time I started it. Also, no error codes on the dash. Thanks
I'm about to go out and check fuses and ignition switch wiring now but I wanted to run the across the group to see if anything jumps out, plus it helps me think through what has changes since the last time I started it. Also, no error codes on the dash. Thanks