gmtech
Active Member
Anyone moved the stock horn off the lower triple tree to get rid of the afterthough location?
moving stock horn
- Thread starter gmtech
- Start date
Wanderer
New Member
Howdy,
No I did not move it but when I installed the OEM PIAA I did use a 90 degree metal bracket so the horn points more out and down instead of in and down.
Later,
Norm
No I did not move it but when I installed the OEM PIAA I did use a 90 degree metal bracket so the horn points more out and down instead of in and down.
Later,
Norm
Attachments
gmtech
Active Member
OK I just moved mine unbolted it amend the bracket that holds the brake line in place. Reinstalled brake line holder in left bolt hole
Undid the zip ties to free up the wiring . then since my genius knows no end and I already moved the stock tool kit under the seat. I pulled the wiring loom behind the engine mount and through the slot where the tool roll usually stays. Then plugged in the horn and drapes in a rag for now, where the tool kit is! Blam horn no longer sits I'm or face look at me , but now hides inside the right side panel. I think the noise that u loose from this is minimal!
Undid the zip ties to free up the wiring . then since my genius knows no end and I already moved the stock tool kit under the seat. I pulled the wiring loom behind the engine mount and through the slot where the tool roll usually stays. Then plugged in the horn and drapes in a rag for now, where the tool kit is! Blam horn no longer sits I'm or face look at me , but now hides inside the right side panel. I think the noise that u loose from this is minimal!