hardpipe
New Member
I work with sheet metal and used our shops laser to cut out an infill panel of .080“ aluminum.
I used a self etching primer with engine paint.
the missing switch is now I installed I just don’t have a picture of it
switches are marine grade 7 pin switches on-off-on
heated grips that I wired in series and in parallel For a high low heat, then I have the two other switches for lights, Baja designs squadron pro’s wired as a high low and a generic led spot light Lower on the crash bar that I need to finish wiring but will be on-off-flashing
I used a self etching primer with engine paint.
the missing switch is now I installed I just don’t have a picture of it
switches are marine grade 7 pin switches on-off-on
heated grips that I wired in series and in parallel For a high low heat, then I have the two other switches for lights, Baja designs squadron pro’s wired as a high low and a generic led spot light Lower on the crash bar that I need to finish wiring but will be on-off-flashing
Attachments
-
85.2 KB Views: 223
-
96.2 KB Views: 245
-
136.8 KB Views: 269
-
133.6 KB Views: 263