Bigguy136
Well-Known Member
I have a 2014 Tenere I bought with 4300 miles on it and the headlights have always been high. With winter here in the north, I can get my to-do things done. I was adjusting the headlights and wanted to understand everything better so I pulled the light housing out. When looking inside the housing, I noticed the light sockets were not solid. There are two adjuster screws diagonal with a 3rd pivot socket. The pivot socket was a ball and socket but the ball was not snapped into the socket. Below is showing an overall where the pivots are located, the before and after snapping the sockets in place. If you are wondering if yours are the same, pull the bulb covers off, grab the wire connector on the bulb and try to move diagonally. It will be secure in one direction but loose in the other direction.
Attachments
-
40.3 KB Views: 68
-
41.2 KB Views: 69
-
35.6 KB Views: 66