Handlebar Risers


New Member
Jun 19, 2020
Hello everyone. I just installed a set 1 inch risers on my 19 S10 ES. I'm concerned about the slack for the hydraulic brake line. The clutch hydraulic line still has acceptable slack but when I turn the bars hard right the brake line seems just a bit too tight. Anyone else run into this and have a possible fix? Are there aftermarket hydraulic lines anywhere? I might try just sliding the brake reservoir handlebar clamp inboard 1/4 inch and see if it helps. I'm 6'3" and when I stand too much bending over in the original bar position.