Do arrow headers fit the T-Rex skid plate?

[Jdubco]

After having my stock header mounting bolt start spinning (at the cat area) and having to take em off to figure out a fix, I though it may be a good time to just move to the arrow headers. Only concern is if they will fit with the t-rex skid plate or if im going to have to trim/pound it out like ive seen some people do with the ACD skid plate. Does anyone happen to have the trex skid plate/arrow header combo, able to help to let me kinda plan my next move.
Thanks

 

[SkunkWorks]

I have the T-Rex skid-plate and the Arrow header on my 2014.
I did not have any interference, but I have read a couple times that people have had issue with the Oxygen Sensors contacting the skid-plate with the Arrow header.
I'm not sure if this is an isolated issue? or maybe a Gen-1 thing?
There may have been a difference in production with the headers also at some point? I think the angle of the oxygen sensor vs the factory Yamaha header is slightly different from what a couple people have said.

 

[Jdubco]

I have the T-Rex skid-plate and the Arrow header on my 2014.
I did not have any interference, but I have read a couple times that people have had issue with the Oxygen Sensors contacting the skid-plate with the Arrow header.
I'm not sure if this is an isolated issue? or maybe a Gen-1 thing?
There may have been a difference in production with the headers also at some point? I think the angle of the oxygen sensor vs the factory Yamaha header is slightly different from what a couple people have said.

good to know so if there is adjustmet for the O2 its likely just to the side edge/lip to on the skid plate that i could deal with. Might just go ahead and pull the trigger on the purchase. Thanks