Herairk
New Member
Hello folks just bought my used 13 tenere w 12k miles and decided to change out to the 14 cct it was a rattling a bit. I removed the clutch cover and zip tied the chain in 2 place after turning and aligning crank position to k to the case.
Removed the tensioner slowly and pulled it out. came out with out any problems. so i put the new one in and smacked it and set the tesioner. verified that the tensioner slider/arm was solid. and removed the zip ties and turned the crank by hand didn't hear a single thing wrong.
so buttoned it up and turned it on to see how it went. and code "14" popped up and can't get it to go off or start the bike.
checked the manual and says " Intake air pressure senor hose" page 8-38/39 did the diagnostic and still won't change anything.
checked the hose and sensor cannot find what is wrong. and i can't seem to delete the code or don't know how to do it properly.
please help, and a big thank you in advance.
Removed the tensioner slowly and pulled it out. came out with out any problems. so i put the new one in and smacked it and set the tesioner. verified that the tensioner slider/arm was solid. and removed the zip ties and turned the crank by hand didn't hear a single thing wrong.
so buttoned it up and turned it on to see how it went. and code "14" popped up and can't get it to go off or start the bike.
checked the manual and says " Intake air pressure senor hose" page 8-38/39 did the diagnostic and still won't change anything.
checked the hose and sensor cannot find what is wrong. and i can't seem to delete the code or don't know how to do it properly.
please help, and a big thank you in advance.