can't change airtemp enginetemp MPG readout

[vetman]

Got the new bike 2 weeks ago, everything great except the topmost readout on the dash is stuck on "air temp", and I can't get it toggle through to the other 3 functions (engine temp, MPG ave, instantaneous MPG, as I recall). Supposed to just push the right (#2) button on the lower right of the dash, right? Nothing happens. Tried with key off, key on, engine running, and while riding, still stays at "air temp." Is there a trick to resetting this? Don't tell me I finally got a new Yamaha with a mechanical defect! I did disconnect the battery once to install power for the radar detector and a SAE pigtail for accessories and charging, but everything else seems to work, and button #2 works OK to set the clock. If it's defective, it'll mean 2 trips to the dealer and leaving the bike there at least a week, or however it takes if they need to get a new dash unit. Any help?? Thanks.

 

[Mellow]

Yup, right button should do it... can you feel the same resistance in both buttons? Maybe the right one is just stuck...

 

[colorider]

Welcome to the Forum vetman!!!! Hope you get the switch sorted out. This is the first we have heard of a problem with this function.

::004::

 

[3putt]

I have had this all apart, the button is a simple rubber insert in front of dash and has a long rubber stem to activate the switch. Since you can set the clock which requires the right button, I suspect the board/solder joint for one of the 4 wires to that switch. Most likely a warranty replacement of dash, doubt dealer will go into it.