Arrow header and slip-on

Tengai

New Member
Joined
Jun 28, 2014
Messages
50
Location
BC
Going to take off my Arrow header and slip-on and put it up for sale. Maybe 4k on the system, gained almost 10hp on the dyno after tuning. no dents. installs in about an hour. also comes with quiet insert. You will need to tune with this system.it flows way more than the stock pipe. Looking for 600 U.S dollars. I am located in B.C. Canada .
Will post pictures when i get the system off my bike.
 

Attachments

Tengai

New Member
Joined
Jun 28, 2014
Messages
50
Location
BC
I had the basic flash installed then put my bike on the Dyno and then the operator tuned my bike to the new exhaust system.. Ended up with a hair short of 100 hp.
 

Rasher

Active Member
2012 Site Supporter
2013 Site Supporter
Joined
Sep 25, 2011
Messages
1,955
Location
UK
Tengai said:
I had the basic flash installed then put my bike on the Dyno and then the operator tuned my bike to the new exhaust system.. Ended up with a hair short of 100 hp.
About same on mine, no end can but headers added about 6BHP pre-flash, and the flash added about the same again leaving me at 99BHP on my ECU-U dyno, I reckon adding a tail pipe should just nudge it past the 100 mark.
 

Breezz68

New Member
Joined
Sep 19, 2014
Messages
19
Location
Lebanon oh
I'm in Cincinnati Ohio anyone know where to get the flash done and did it effect your fuel mileage I'm getting on highway loaded 50+ mpg
 

snakebitten

Well-Known Member
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Joined
Aug 6, 2011
Messages
5,681
Location
Coastal Texas
Tengai,

If you had posted on say.....November the 14th, instead of the 19th, you wouldn't be bumping this thread. :)
It'd have been shipped to Texas already.

good luck though. That's nice kit!
 
Top