Air Horn Mount

TOS

Member
Joined
Nov 19, 2016
Messages
53
Location
Southern OK
I got a air horn off eBay last week for $15 and free shipping. It looks just like the Stebel I installed on my Wee a few years ago.
Anyway, this is where I decided to install the horn. Wiring not complete yet, waiting on PC8 to arrive. I did test it and it sounds like a air horn, not like the horn on my first Moto... 1969 80cc Yamaha Trail Master :).
 

Attachments

ace50

Active Member
Joined
May 19, 2015
Messages
640
Location
VA
Not bad, I just don't like the looks of them shoved somewhere. At least you realized those are much better than the stock horn.

I bought the same design, I just separated the motor from the horn. Horn under the headlights (hardly noticeable) and motor where the tool pouch goes.
Tools went in a 30 cal ammo box in with a small air compressor for emergencies!
Ammo box on right side balances the look with the exhaust on the left side, somewhat anyway............
 

limey

Well-Known Member
Founding Member
2011 Site Supporter
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Joined
Dec 13, 2010
Messages
1,913
Location
Bowmanville Canada
ace50 said:
Not bad, I just don't like the looks of them shoved somewhere. At least you realized those are much better than the stock horn.

I bought the same design, I just separated the motor from the horn. Horn under the headlights (hardly noticeable) and motor where the tool pouch goes.
Tools went in a 30 cal ammo box in with a small air compressor for emergencies!
Ammo box on right side balances the look with the exhaust on the left side, somewhat anyway............
I did the same thing ace, been there for 5 years now.
 

TOS

Member
Joined
Nov 19, 2016
Messages
53
Location
Southern OK
Only problem I foresee with my mount, is deep water, which i hope doesn't happen. lol
 

snakebitten

Well-Known Member
2012 Site Supporter
2013 Site Supporter
2014 Site Supporter
Joined
Aug 6, 2011
Messages
5,681
Location
Coastal Texas
If deep water was a threat to the horn, Limey's would be dead. ::013::
 

Jono49

Member
Joined
Oct 12, 2016
Messages
112
Location
Scottish Borders
Fitted mine recently, in between my Puig engine bars, using a bit of stainless fat bar 3mmx 25mm took a bit of grinding and bending, and a m8 hole to drill for the horn to mount to it, then I mounted it using the engine bar mounting points, and I don't think it looks out of place there, I used the original horn wires to pull the switching coil in on the 30amp relay, and left the original horn in place in case it's ever needed in case of the denali failure ??? and boy is it loud ::008::
 

Attachments

Top