Saint rob
Well-Known Member
I've tried various searches but I'm still not clear whether it's possible to check for/read or just simply delete any ABS codes.
A bit of back story, the bike is a 2018 Z (so a UK bike and no electronic suspension) and the ABS light came on solid after washing the bike following a recent trip. Everything was working perfectly before and during the trip - and I know I should have just left it dirty instead of washing all the Scottish midges off, but I've never seen so many of them
I've tried the following:
Removed and cleaned both wheel sensors - no chewed or frayed wires
Removed both wheels and cleaned the the abs rings with switch cleaner
Removed and tested all 3 fuses
Disconnected both battery terminals, cleaned and reconnected them
Jumpered the black/blue lead and switched the ignition on with the kill switch off to successfully cycle the pump
Connected an OBD tester to the diagnostic port near the fuse boxes and it doesn't show any DTC's - but then I didn't expect it to
I haven't yet followed the sensor wires through and checked where they connect to the main wiring harness - that's tomorrows job, along with checking any connections to the abs ecu and pump.
I'm pretty certain that it was a dirty sensor/ring issue but I can't figure out how to check for codes and delete them, the light just stays on solid with no flashing - until the blue & black wires are jumpered and then it flashes.
Can anyone help or suggest anything else to try please?
A bit of back story, the bike is a 2018 Z (so a UK bike and no electronic suspension) and the ABS light came on solid after washing the bike following a recent trip. Everything was working perfectly before and during the trip - and I know I should have just left it dirty instead of washing all the Scottish midges off, but I've never seen so many of them
I've tried the following:
Removed and cleaned both wheel sensors - no chewed or frayed wires
Removed both wheels and cleaned the the abs rings with switch cleaner
Removed and tested all 3 fuses
Disconnected both battery terminals, cleaned and reconnected them
Jumpered the black/blue lead and switched the ignition on with the kill switch off to successfully cycle the pump
Connected an OBD tester to the diagnostic port near the fuse boxes and it doesn't show any DTC's - but then I didn't expect it to
I haven't yet followed the sensor wires through and checked where they connect to the main wiring harness - that's tomorrows job, along with checking any connections to the abs ecu and pump.
I'm pretty certain that it was a dirty sensor/ring issue but I can't figure out how to check for codes and delete them, the light just stays on solid with no flashing - until the blue & black wires are jumpered and then it flashes.
Can anyone help or suggest anything else to try please?