Recent content by orrr

Two weeks, almost 5500 km and six countries, just DCT Corsica....

I bought a drive shaft protector (OEM, second hand) but without a mounting elements and an instruction. Fortunately i found first page installation instructions what allowed me to define missing elements, but I need the second page describing way of mounting. Is there anybody who can help me...

Winter has come... so, I decided for periodic maintenance. New oils, filters, cleaning and lubricating pivots, checking and tightening spokes if necessary. But the main task was chain tensioner - I replaced it... ::025::

Polish mountains... PIENINY

This is my proposition how to attach a top bag to an OEM side pannier. Holders are made of aluminum (1,5 mm). Are easy to made and detachable. I think that pictures show everything....

The bearing sizes for the rear wheel... P/N 93306-27212-00 source: http://www.pivotworks.com/ProductInfo.aspx?item_id=52669 KOYO bearing: http://bearingsize.info/catalogue-online/deep-groove-ball-bearings/podshipnik-62-22-2rs-koyo-obj120113.html P/N 93306-00521-00 source...

I have just got an electronic module, it works excellent. A new box and control panel were designed, i hope they will printed next week....

New Valkyrie you are saying.... How to say.... quite radical solution ::) after replacing mounting system I recognize the issue as closed...

THX.... :) To produce and sell.... it wasn't my intention but I can help if someone is interested. I still working to reduce number of switches. In my opinion :lamp: it possible to reach the same effect using one switch (I think about controlling aux lights) but it requires an electronic...

More informations, pic...: http://www.yamahasupertenere.com/index.php?topic=21516.msg307137#msg307137

As I mentioned in another post I designed switches panel for operating auxiliary light. The body is prepared for APEM 9433 NCD switches: http://www.apem.com/files/apem/brochures/switch-pushbutton-9400-9600-ENG.pdf with sealing bots U1403 ...

Winter period is good time for working... finally I decided to buy upper crown and clamps and replace with old parts. New parts are expensive..... I bought used ones. Everything fits, just "plug and play", the hardest part of working is dismounting of main switch (special secure bolts are...

You suggest to readjust vibration's frequency of handlebar :lamp: ..... good idea, thx for advice.

To replace the crown I need to know two parameters (I hope). Distance between outer tubes and their diameter. I assume that there isn't modifications in elements of steering head. Will see.... :lamp:

Thanks for reply... yes this is too expensiv and so more I am not going to rebuild an engine.... no way... this is similar to Yamaha solution, both use rubber as isolator (part 11, pic. 2). Thx... I will try to get some information from Yamaha. If I get answer I will share it.