Recent content by flash

Sold

Left side, front, and rear pictures as requested.

Pics of GPS and mount

Also included in the sale: 2nd Garmin Zumo 550 GPS that I used for a backup (2 total) 1 spare battery for Zumo 550 2 replacement touch screens for Zumo 550 8 Yamaha branded oil filters 2 Yamaha branded air filters 1 set of front spokes with several nuts missing 1 set of rear...

It is the 58L.

The bike has Bridgestone A40 tires on it. They were installed 10/28/17 with 17422 miles showing. They should go another 4 to 5 thousand street miles. At the same time rear brake pads were installed. The bike was last serviced on 07/4/18 with 19759 miles showing. The bike needs nothing that I...

Garage kept in excellent shape; never down. Has a little less than 21000 miles. Has Bumot panniers and tool box, Givi Outback Trekker top box with passenger pad, AltRider engine guards, Seat Concepts seat, Garmin Zumo 550 GPS with locking cradle, and Yamaha wind deflectors. Located in Western...

For sale a Sargent seat. I purchased this seat new in Oct. 2016. My wife was unhappy with the stock seat and we tried this. However, she didn't like the Sargent any better. The seat probably was ridden on less than 500 miles. It appears much as new; it does not even have a heel scuff on it...

Thanks for all the replies! Today I trued the front wheel and it completely removed all the shake in the front end and handlebars. I think most of this was self inflicted by not using good technique when torqueing the spokes. The rear wheel needs truing as well, but that will have to wait for...

I'm thinking now that I don't understand how to calculate rim run out. If you use a dial indicator and find that the high side is .100 inch higher that the lowest point, does this mean that your runout is .050 inch? If so, I misstated my runout. It would be .095 inch for the front and .075 inch...

Yes I used a Snap On torque wrench set at 53 in/lbs. I tightened going to different positions on the rim in an attempt not to change the runout. However, many were very loose requiring several turns to tighten. It is very possible that I could of changed the runout some as more than 1/2 needed...

Three months ago I purchased a new 2016 ES model. I just turned over 4000 miles on it. The bike has always seemed to have excessive head shake. You can feel light vibration in the bars while holding on. If you release one of the bars at any speed over 25 mph the bars have about a inch or so...