Baja Designs Squadron Pro Install help

[FalArAk]

So I just picked up a set of these and decided to just hook them up real quick and see how they look before I decide where to mount them.Unhooked all the bikes power so I am just using the Shorai lithium battery.

Hooked the two leads that come with the universal wiring harness to the battery.On that same set of wires with the leads,there is a on/off switch,15 amp fuse and the connector for the lights.

Plugged the "Y" cable that goes to the lights,with the single plug going into the harness mentioned above.

Flip the switch,the switch lights up,but no lights ?

Am I doing something wrong,it seems kinda simple to just run a test.For giggles I hooked everything back up,started the bike and same thing happened,Baja switch lights up,but no Baja lights.I will eventually run these lights through the Rowe PDM,but wanted to check them out first.

 

[OldRider]

I don't know if you can hook the polarity up backwards or not, but I would check that.

 

[FalArAk]

You mean hook the red wire up to the black terminal and vice versa,I didn't do that..But I did go double check anyway haha

 

[Checkswrecks]

Time to get out the multimeter.


Check continuity of the fuse. (Probably good since the switch lit but it's the easiest and quickest to check.)


Check the continuity of the wire harness from end to end.


Switch the multimeter to check the LEDs. Simply Google how if you don't know how.

 

[FalArAk]

Gotcha,thanks.Going to do that today.

 

[OldRider]

You mean hook the red wire up to the black terminal and vice versa,I didn't do that..But I did go double check anyway haha

I figured you had the red & black at the battery correct, but like Checker said, check the polarity all the way downstream.