SpeedStar
XT12 and DL650
Founding Member
2011 Site Supporter
2012 Site Supporter
2013 Site Supporter
Vendor
I added adjustment marks to three surfaces on each side of my WaspWorks screen mount to make getting it even on both sides much easier. Just scribe a small mark in .25" increments on the three surfaces in the pics below. Make sure you mark them accurately from the same starting points.
Once you have the marks, it is easy to identify that it is even.
You will also be able to document setups that you like to be able to go back to that setup in case you have multiple setups that you use.
Greg, any possibility of building this in to future parts?
Here are the three pics.
Once you have the marks, it is easy to identify that it is even.
You will also be able to document setups that you like to be able to go back to that setup in case you have multiple setups that you use.
Greg, any possibility of building this in to future parts?
Here are the three pics.