Search results

2014 Yamaha Super Tenere Under 9k miles Heated Grips Cruise Control Heat Troller for Jacket/Pants and Gloves Mount for Garmin Madstad windshield adjustment for height/rake PIAA fog lamps Caribou Cases for side and rear Touratech brake pedal 4 years of Yamaha Warranty, unlimited mileage. All...

OK!... So my bike stinks. I can't figure out why. My Installed accessories: Wolfman tank bag, strapped on w/ nylon webbing. It is wrapped around the frame in the front and under the seat in the back I've checked for loose strapping, damage to strapping, etc. Verified that there is no damage...

Nailed it, I had both panels off so without the panel there, there was nothing to find. I figured it out after I put her together. I looked at the back of the panel, but only for the male end... had to have looked right at it. Sent from my SCH-I545 using Tapatalk

Looked all over on the right hand side... couldn't find where it could be. It is not quite round... instead it is more ovalized. should've taken the photo from a better angle. Thinking of taking the drivers left cowling off again to see if there is another beside the one to the right of the fan.

There is one just like it part of the cowling slides into on drivers side left near the fan. I couldn't find a similar hole, drivers side right. Both cowlings were removed (well... all three technically) and the tank was lifted. Spent two hours looking for the hole that this thing came from...

Sent from my SCH-I545 using Tapatalk

Forgive me for not posting a foto... I'll try to get one up shortly. I had to pull the tank today to get a wire/loom from under the seat to the front of the bike. In the process, the drain tube disconnected itself. I had to loosen the tubes to get them back on. In the process an rounded edge...

I do not have a PM from you boomer

I've got a 1200 watt sprint on the bicycle but not enough leg to push start the s10. I've been able to get my old 650 vstrom up as well as the bike before that, a suzuki m50. Hell, I've even been with a group of guys that that push started an EFI hyundai elantra. Tried 2nd gear, no luck...

I have sold the bracket

apologies, the notifications were going to my junk folder- issues been resolved and PM's responded to.

I have some 'extra' parts from my 2012 Tenere for sale. First is a Madstad windshield bracket. I would like to get 85$ for this, shipped. I have this posted on Adv rider right now as well with photos. Second is an Excel Throttle Lock. I believe it is the gen2. This I would be happy to sell...

Few changes: Will come with: PIAA headlamps Dash infill kit Heated handgrips Givi Crash bars Yamaha Skid Plate $7800 Optional: Excel Throttle Lock $100 12,000 miles 1000 miles on e07's All fluids changed/maintenance performed Will post pics ASAP

It is seeping. Pretty sure it was the filter cause I only tightened it hand tight. Bought a wrench to snug it up and... crushed the filter. New filter, problem solved.

Torqued the plugs to 14 ft lb with new crush washers. It's not a lot of oil that's leaking, but definitely enough to let me know there's a problem. Again, crush washers were new and the bolts and washers were clean before they were reinstalled. What's my next move?

My big secret... I struggled getting the bike on the cs until one day I realized it was infinitely easier if I made sure the handlebars had the wheel pointed straight ahead. I dunno if this is common knowledge, but once I figured it out, it was like someone flipped a switch.

What is considered local when it comes to Teneres? Judging by the first post, in or near brown county? I am sure there is more than one indian/victory dealer in wisc.

Dash panel. Pretty happy with the result.

Got mine put on today. Elected to finish off with some leftover spray on bed liner. Had some scrap auto trim left over and it finished it off nicely. Showed my wife and it took some convincing that it wasn't factory.

Aussie