Search results

You can see the "rings" on the rubber where the topcase now sits.

Here's what I did to reduce the slack below the topcase. Just do the same on both L&R sides.

Mine was the same. Just remove the box and glue some rubber shims to the mount to take up that extra little bit of slack. Mine "moves no more" !!

Exactly! You described my problem to a T !! Warped to the point of having approx 3/8" of space at the topcase seal at either end. They were obviously not "flapping in the wind", but I could envision an eventual lock failure and/or water leak problem in the future if I didn't do anything to solve...

I know a lot of us are frustrated with how loose & sloppy the Yamaha OEM topcase lid can be even when it's locked! I picked up a 2-pak of these "Spring Loaded Butterfly Twist Latch Keeper Toggle Clamp for Case Box" from Amazon, and they keep the lid closed nice & snug! They JUST fit !!

My FIRST S-10 !! So far very impressed! Coming from a "2 bike household (650 V-Strom & Gold Wing) this is the PERFECT balance between the 2 !!