Search results

  1. H

    Just ran the bike in gear on the stand...

    Cheers. I'll give it a run in the morning when it isn't hammering rain. I knew they disabled ABS this way, but when key off and re-start the engine light and ABS both came on. :rolleyes: Aside from this, any quick directions on how to CLEAR or reset codes on a Gen 1? I know there's every bit of...
  2. H

    Just ran the bike in gear on the stand...

    Look, I know people get narky over questions asked for the millionth time, but I've searched and not found. That's another thing. Short story, did a service and changed everything, checked air cleaner etc then decided to warm the bike up and circulate the oil in the final drive while the...
  3. H

    Got a bit of a clatter...

    Thanks for the replies and advice legends :cool: I'll take it all on board and check all those things. A bit of an update on that... There's torrential rain in Tasmania at the moment so I figured there's no better excuse to open a beer and give it a big birthday. All fluids changed, check all...
  4. H

    Got a bit of a clatter...

    of course you have to ride it sideways. I haven't had it long so I'm just realising that they get pretty loose without too much trouble. All that aside, you're right on the money with the conditions and symptoms.
  5. H

    Got a bit of a clatter...

    Sometimes you'll get the same name for completely different parts, even in the manual. Just wanted to know if it meant engine or driveline
  6. H

    Got a bit of a clatter...

    This is going to sounds ridiculous, but what are you referring to by "cross shaft"? As in gearbox or final drive?
  7. H

    Got a bit of a clatter...

    Is there a reason they have issues with those? 20 thousand kms?
  8. H

    Got a bit of a clatter...

    Cheers mate, no drama. I'm guessing too at this stage. I'm actually a mechanic which naturally makes me listen to EVERYTHING and I may even be being paranoid, it could be normal for these but once I heard it... I couldn't unhear it. The best way to describe it, is... you know that rattle...
  9. H

    Got a bit of a clatter...

    Hey Donkey Yeah it's a strange one, if it happened to my YZ450 I'd swear it had done a bottom-end, but this seems to only be on loose surface when I'm asking the rear to step out. Certain load and revs, TCS off, pulls smooth then horrid rattle then goes away. There are a lot of things that need...
  10. H

    Got a bit of a clatter...

    G'day all! Going to ask a question that's probably been asked before, and to start with, yes I've searched the site and done the research on CCT's. 2010, S10, 21,000kms. Today's ride was 50/50 on road and on loose gravel tracks. On the gravel, I switched the TCS to either 2 or off...
Top