MAUAN's latest activity
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.update : abs gen1 worked normaly for gen2 -
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.u didnt understand me right the the fault code apears is 042 apears when abs plugged or unplugeed the same so the abs no communicating...
-
Burned, it shouldn't be (you said that the fuses of the abs motor and the abs ecu were fine)...a communication problem, in a digital...
-
i thought a connection wire etc is more likly than the module failure rob
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.thank u for ur interest but about wiring i test all canles one by one there is 4 if i remember wired to the engine control module all...
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.yes i scaned the bike with yamaha diagnostic and no communication with abs module
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.042 like rear abs sensor but same fault even with abs plug plugged or not still only 042 and i try to cycle abs by jumping two wires...
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.thank u man
-
Here is the old thread. That poster successfully used a 2017 abs in a 2011. Oops wrong url. Be back in a minute...
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.yes cuz i didnt find gen2 abs i found only gen1 abs and its used ... about buying new is too expensive ... that why im asking if it will...
-
Update The 2017 abs unit is on the 2011 bike ,and the problem is fixed. Both of the bikes are Europe models, I don't know if there is...
-
I'm not saying your case could be the same but that the fault lies elsewhere. These sensors are pretty simple and unless they have some...
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.im facing a electrical problem with my module the electric unit is bad no communication with diagnosis with it and no speedo... that why...
-
MAUAN replied to the thread GEN1 ABS FITTING ON GEN2.i tried to search this thread and i didnt get to it
-
i,m sure i read a thread on here awhile back that somebody fitted a gen 2 abs pump to a gen 1 bike few years back now somebody else may...
