Recent content by KipperKahn

Finally got my USB / Volt / LED Switch Panel finished. I used 1/8" Kydex T Sheet for the backing that the plugs and switch are inset.

The 5-pin came with the wiring harness, thats the reason i planned on using it. The bottom right pin is the built in Blue-LED in the switch.

OK, so before i go blow something up, anyone want to check that i have my wiring correct for my project. :) I have a the relay, fuse and a 5-Pin Rocker switch so i can turn off the LED lights if needed but still use my high beam lights.

I have a LED Wiring harness with a switch/relay/fuse. Plan was to wire that to the high-beam wire for power and run the ground to the Battery.

New owner of a 2018 Super Tenere ES. I picked up a couple 60W LED light bars with the thought of splicing them directly into the high beam circuit. Combined, the High Beam and LED Light bars would be 20A i believe. Can anyone tell me what the max amp that can be put through that circuit?