Recent content by grouseridge

Installed some Galfer Semi-Metallic Carbon front pads @ 30k miles which made a nice improvement over the OE'. Lubed the shifter pivots with Miltec 1 (my synthetic 1911 guide grease which doesn't attract dirt) and made for easier shifts. Changed the oil/filter with Rotella T6 and Wix oil filter...

Re: Tires available in Super10 sizes, a comprehensive list Still had 1/16" till the rear was down on the wear bars at 9400 miles on these TR91' and replaced them with another set of TR91' before the trip, have no complaints with these all terrain tires.

Re: Tires available in Super10 sizes, a comprehensive list Have 1000 miles on a set of Dunlop Trailmax TR91' and they seem like no warm up is needed, very sticky on the mountain curves with nice lean in, even some logging roads, 1' deep rivers (no mud) with out any problems. Time will tell on...

Cycle world in Athens had the best out the door price at the time I bought mine and I checked neighboring states too.

Happy with the results of Collinite 845, it even makes the gray a little darker and it even goes on my windscreen too.

little over 8k miles so far and have done some handlebar risers, crash bars, grips, seat modifications at the upholstery shop, airhawk and engine skid plate. 5th gear is getting quieter and the rear oe exp' has about 2/32"-3/32" left, the trail wings are going on soon. Enjoying this cycle.

My thought with the Osram Rally 65 Watt H7 would cause problems with bulb sockets and harness. The bike did have the recall harness done. Has anyone run these bulbs before with success?

When the recall was done before new bike delivery, they forgot to plug in the left high beam wire.

Don't know if this is normal with having only the right light go to high with the high beam switch on, or are they both to change? Thanks

6'3" what works for me is 1" handlebar risers, installed two 5/16" flat washers under seat lock bolt, then added 1/4" thick rubber washers under front part of the plastic seat tray and took the seat to the local seat upholstery shop and they cut 1" out and added 3" of high density foam and a...

This simple mod gives great throttle response, glad it was here to read. Thanks

Thanks guys, lots of great information on the forum.

Just got back on a bike after a 35 year break and after a long search and lots of research I bought a new 2013 Tenere. This forum has helped with the mods I have done to the bike. Thanks

Being 6' 3" I went with the 22" Parabellum, I wanted the air hitting the top of the Shoei Quest. Can ride with the shield open at 55mph and close it above 55-60.

I had not rode a motorcycle for 36 years and all the sudden I thought it was time to have a motorcycle again. So the search began and being 6' 4" it was hard to find something that fit, I sat on cruisers and some different enduro/adventure type bikes for about two months and decided to go with...