Ive posted this info before in a different thread about the rear rack... space underneath.
Since all the electrical components are located under the right side panel....I decided to move the tool pouch & put a set of battery jumper cables in its place.
I had a rear rack mount custom made to...
If anyone is interested in buying these....
I have a set in similar condition but with the cleated surfaces instead of the rubber.
I would be interested in swapping the cleats for the rubbers even up. Either one is avail new for $55 from Knight so a swap would save the cost....well cept for a...
have a complete 3 pair set of semi sintered Galfer pads to fit all Super Tenere XT1200Z models for $60 + $10 to ship if needed
Front FD178G1054 = to EBC FA380V
Rear FD295G1054 = to EBC FA319/2
These will also fit many other Yamaha models...but you need to check fit
Code 30.....no start.....I wonder why??
There was a ton of chewed up paper nesting in the MouseMotorhome under the rear seat. I cleared out most of it before this pic. Evidently...the lean angle sensor wiring was blocking the rodents hallway.
I had let the Ten sit for a...
I like the 14up Strom 1000s cuz theyre more "sporty" feelin than the Ten & appx 75lbs lighter too. Its my hotrod
The Ten is the traveller with cruise & the shaft. More comfy too
The Ten also goes slightly further on a tank (5.3gal vs 6.1 on Ten) Ten mpg is slightly better too.
These 2 Stroms are in my garage rite now....along with the Ten
2014 Strom 1000 #2 w 10k ( I sold the 1st 2014 at 30k)
& a 2013 650 Strom w 12k (I had a 2012 650 in 2016..soon after buying my 1st Tenere....a 2013 white one
Im now on Tenere #3....a 2014 blue one
Bought in 2019 with 10k...now has 30k
This is a brand new in the box Cruze Tools Econo Kit Metric.
A pretty complete kit in a zip up carry bag....not much larger that a stock toolkit. Even includes a red shop towel zip ties & elect tape
$50 shipped from Waco Tx to US 48