Senor Ramon
Member
So I followed an excellent tutorial on this board how to remove the rear wheel (because I had to replace the rotor and then pads). I followed the instructions carefully.
It seems like the before and after pics differ such that the rotor side axle washer and swingarm seem more spread apart now (greater distance) than they did before I took the wheel off the bike. See before and after Pictures. I tried to ensure that the wheel was snug with the drive shaft side. I torqued everything per the service manual.
I then test rode the bike today twice. It felt normal with improved braking.
So do I have anything to worry about? Should I take it apart again? Should it be more flush with the swingarm?
After pictures
Before picture
It seems like the before and after pics differ such that the rotor side axle washer and swingarm seem more spread apart now (greater distance) than they did before I took the wheel off the bike. See before and after Pictures. I tried to ensure that the wheel was snug with the drive shaft side. I torqued everything per the service manual.
I then test rode the bike today twice. It felt normal with improved braking.
So do I have anything to worry about? Should I take it apart again? Should it be more flush with the swingarm?
After pictures
Before picture
Attachments
-
99.8 KB Views: 96