Yes, do not install the crash bars until you are finished your wiring.
Sorry, but what is a centech??
Assuming an electrical device.
Since you have a 2018 year like I do. I would suggest installing something like a power commander (I didn't). I used a 12 volt relay to wire most items such as LED lights (3) so the lights will only go on with the key in the on position. I used the bikes aux plug which you will find embedded in the wiring. R.H. panels removed, strong flashlight along with a screwdriver to gently push some wires aside and then grab the aux plug with a small pair of locking pliers. It's a bitc* to locate.
I posted photos earlier on this topic. You will need the compatible plug that plugs into the bike's aux plug. I got mine from electrical connections.com p/n 08111 and 08112
EricV is a very good resource along with Mac10.
I'll try attaching some pictures
Be sure to remove the cap from the bike's aux plug so you can plug in the white colored plug that I used.
There's certainly other ways to do this obviously. Good luck and take your time and for god's sake remove, tape and isolate the negative battery wire. Aux plug located approximately 2-3 inches to right of battery and 2 inches above battery.
SHUMBA
View attachment 56298View attachment 56299View attachment 56300
Hi
Is this heated grip plug in the same place on a 2011 S10? I am a bit dubious about fiddling in the mass of wires as I may struggle to be able to get them all back in place if I pull them out.
Any advice will be greatly appreciated
Thanks
Damian