Question about fuse box or power supply??

[Damian]

Yes, do not install the crash bars until you are finished your wiring.
Sorry, but what is a centech??
Assuming an electrical device.
Since you have a 2018 year like I do. I would suggest installing something like a power commander (I didn't). I used a 12 volt relay to wire most items such as LED lights (3) so the lights will only go on with the key in the on position. I used the bikes aux plug which you will find embedded in the wiring. R.H. panels removed, strong flashlight along with a screwdriver to gently push some wires aside and then grab the aux plug with a small pair of locking pliers. It's a bitc* to locate.
I posted photos earlier on this topic. You will need the compatible plug that plugs into the bike's aux plug. I got mine from electrical connections.com p/n 08111 and 08112
EricV is a very good resource along with Mac10.
I'll try attaching some pictures
Be sure to remove the cap from the bike's aux plug so you can plug in the white colored plug that I used.
There's certainly other ways to do this obviously. Good luck and take your time and for god's sake remove, tape and isolate the negative battery wire. Aux plug located approximately 2-3 inches to right of battery and 2 inches above battery.
SHUMBA
View attachment 56298View attachment 56299View attachment 56300
Hi

Is this heated grip plug in the same place on a 2011 S10? I am a bit dubious about fiddling in the mass of wires as I may struggle to be able to get them all back in place if I pull them out.

Any advice will be greatly appreciated

Thanks

Damian

 

[SHUMBA]

This aux plug I described and used to connect my three LED lights is NOT the heated grips plug. There's a separate plug that is used to connect the heated grips.
On my 2018 Super Tenere heated grips are standard, that is the bike already has heated grips. But the plug for the heated grips is in the bike's wiring on the lower right hand side. I have seen this heated grips plug when I did the wiring for my LED lights. The heated grips plug looks similar to the aux plug but instead it has 4 connections vs only 3 on the aux plug.
Suggest you find EricV or Mac10 on this forum. I'm sure they can add to this.
Anyway, hope this helps.
SHUMBA