No Headlight

[ROBERT PRESTON]

I have no power to head light, fuse and relay are good and dimmer is functioning. power not getting to headlight where is the connection?

 

[WJBertrand]

Make sure the engine is running. There will be no power to the headlights until after the starter switch has been actuated.


Sent from my iPhone using Tapatalk Pro

 

[Cycledude]

Sometimes both headlight bulbs are burned out.

 

[bimota]

check bulbs alot of the time as said both bulbs gone

rob

 

[WJBertrand]

check bulbs alot of the time as said both bulbs gone

rob

Yup, first one burns out and goes unnoticed until the second one goes out. Also if you have an early Gen 1 model there was a recall on the headlight wiring.

 

[Bill_C]

I have an issue where my the plug end that attaches to the headlight come loose ALL the time and I have to open up the cap and reseat the plug. It's just worn out a bit... or the male end on the bulb is a tad small, not sure which.

You might just check that first. I can't be the only one with that issue and it's an easy thing to check.

Edit: Scratch that. I just went to pull the cap and swap in LED bulbs and noticed that my issue is actually with the female plug. One side of the connector has a wire pulled partially out so it's not making a good connection. I need replace it. You might check your plug wires as well, but I doubt that's it.

Sent from my SM-G955U using Tapatalk

 

[ROBERT PRESTON]

Dimmer switch gets power from same relay as head light, dimmer is working head light socket has no voltage.
looking for a bad connection or bad wire not sure where that connection is located

 

[Cycledude]

Dimmer switch gets power from same relay as head light, dimmer is working head light socket has no voltage.
looking for a bad connection or bad wire not sure where that connection is located

Make sure the engine is running. There will be no power to the headlights until after the starter switch has been actuated.


Sent from my iPhone using Tapatalk Pro

maybe you missed it, no power to those plugs until the engine is actually running, just turning on the key doesn’t power those plugs the engine needs to be running