I'm still a little confused as to how/ where/what to connect to with my new 2018 S-Ten ES so I can install two LED lights along with a 12 volt socket mounted to the handlebars.
I'm planning to use the white socket that plugs into the bike's 3-pin aux light socket. Please see picture.
View attachment 53250
Do I need to use a relay with the four connector points #30, # 85, #86, and #87 to make this happen? The plug that attaches to the bike's aux light plug- in has three wires, red, black and brown. I'm told the red wire goes to each of the LED lights, and the black wire would go to the on/off switch that I will mount onto the handlebar. But how do I integrate this white plug with three wires into the relay if I have to use the relay? I want to have these lights to come on only when the key is on and I can control the on/off with the interrupter switch.
As for the 12 volt socket installation, I can easily just connect each wire (red and black) directly to the battery, with a fuse close to the battery, because it will be used to power a portable air pump, otherwise it will have a rubber cap on it most of the time. I will power my dash video camera and my GPS by plugging into the bike's 12 volt socket by using a splitter, that is plugging into the bike's socket and then have two females to plug the camera and the GPS onto. Appreciate advise from someone out there who has done this start to finish using these plugs.
SHUMBA