Moto mosko rack

Dons 1911

Well-Known Member
Joined
Jul 18, 2020
Messages
266
Location
Rathdrum, Idaho
I had to make some spacers for the mounting wedges to mount the Back Country 35's on the SW Motech racks. This was necessary for the hard part on the back of the bag to clear a bolt head in order for it to slide onto the wedge. That doesn't look necessary with the Outback racks. Looks like the mounting tabs are welded centered on the tube as opposed to the outside of the tube...nice! They look stouter too!
 

SuperTforme

Member
Joined
Jun 12, 2019
Messages
40
Very easy to install


Sent from my Pixel 2 using Tapatalk
It looks like the rack is symmetrical coming off the center of the bike out past the exhaust on one side and the same distance on the other side correct? Trying to decide if I should get the offset bag set MOSKO offers which is a 25L left and 35L right....but based on this picture I think equal sized bags would look much better? Do you agree with that? Im thinking going dual 25L.
 

SuperTforme

Member
Joined
Jun 12, 2019
Messages
40
It looks like the rack is symmetrical coming off the center of the bike out past the exhaust on one side and the same distance on the other side correct? Trying to decide if I should get the offset bag set MOSKO offers which is a 25L left and 35L right....but based on this picture I think equal sized bags would look much better? Do you agree with that? Im thinking going dual 25L.
Actually, I think I see where the exhaust side is just a hair wider with the last piece of tube just before the bag mount section. Maybe 1" or 2"
 
Top