Headlight back extension

[ThaiXT]

Just printed these they take the original headlight back and seal (to be fitted) fits as standard but gives extra space for bulb change printed from heat resistant and UV resistant PLA

 

[Longdog Cymru]

Will you be printing and selling these?

 

[Check6]

Yes pls do tell

 

[Don in Lodi]

There is a guy printing entire extended caps, no spacer needed.

 

[ThaiXT]

Once perfected yes I could sell, these ones just catch the fork so I am modifying

 

[ThaiXT]

Getting there now with the design

 

[ThaiXT]

I have now modified and under test I have added .5mm to the seal area and made a seal cutout for better seal contact, added an inner section so when attaching the original cover it has an outer and inner so I can fit an internal seal, I will post pictures later

 

[ThaiXT]

Photos attached

 

[Cycledude]

Seems like a nice design, looking forward to hearing about the actual in use test results.

 

[ThaiXT]

I have tested the design I have managed to fit Philips led H7 bulbs they're so much brighter, the original cover fits very well I used back silicone to seal, the adaptor ring fits ok into the headlamp but I am not 100% happy so I am making a few changes and reprinting, good thing is they stayed on the bike no problems for over 800klms now

 

[ThaiXT]

Design seems to ok now I am going to order some seals to test as I just used silicon as a seal which works fine, I have washed my bike several times and had no leakage ;-)

 

[Thor]

Hi
I am also busy doing a 3D model,
to extent the H7 LED light .Can you assist me with the 3 D program Please????? cant extend the cone area to fit whole unit inside the cover

 

[ThaiXT]

Hi
I am also busy doing a 3D model,
to extent the H7 LED light .Can you assist me with the 3 D program Please????? cant extend the cone area to fit whole unit inside the cover

I wouldn't give the program away it's taken me hours to make, thanks