ES model rear spring upgrade spacers

[sblissner]

The purpose of this thread is to gage interest in top and bottom spacers to facilitate increasing the spring rate on ES models.

I would be having a local machine shop make a lower spacer per Karl's drawing and an upper spacer similar to the Racetech piece, shown by Super08 earlier in this thread, to take up the space between the upper body and the spring i.d..

Don't have a price yet, I'm sure it will depend on interest and my ability to spread any setup cost over more pieces.

If your would be interested post a reply in this thread. If there is enough interest then I will take drawings in and get a price.

Personally, $100 for the set won't dissuade me. It needs to be done in my case as I weight 240 and travel with full camping gear.

 

[Rammer_72]

I'm interested as I have a few pounds on you and need to address the suspension rear and front. If you are only having a few sets made I can see a $100 price but if more can be done at once then the cost should be a lot less than that.

Of course then for myself and my fellow frost-backs I have to factor US-CDN exchange and shipping... LOL.

Yup, still interested!

 

[sblissner]

Taking drawings in to shop Monday.

Should be able to set a price later in the week.