Dimensions needed for modified dogbones on 2012 Super Tenere

[Stretch Joubert]

HI there,
I am just under the 2 meters tall and decided to lift/rise my ST by shortening the dogbones to 95mm from 111 mm(bolt center to bolt center) Can someone help me with the hole size for the Dogbones? Mine is still on the ST and I need to supply the dimensions to the engineering workshop. I need the correct bolt size to ensure no play on the setup.

 

[bimota]

can,t you just take the nut off the other side of the bolt and measure the bolt

 

[Stretch Joubert]

The S10 is at home and I am at work. I want to speed up the process of getting the new ones made

 

[bimota]

The S10 is at home and I am at work. I want to speed up the process of getting the new ones made

oh ok that makes sence sorry

rob

 

[fac191]

The S10 is at home and I am at work. I want to speed up the process of getting the new ones made

Relying on someone else's measurements would seem somewhat " risky " unless it's right. Just saying.

 

[lund]

I would let the tech or engineer as you guys call them do the measuring. Letting them figure it out is best that way if there is a screw up its in their hands and not yours for not supplying the correct info.

 

[Mr. BR]

or, you could just call these guys: www.lustracing.co.uk

 

[Stretch Joubert]

I had the part made and gave them a smaller diameter for the holes, I thing 13 mm, I am going to take both old and new dog-bones to the metal shop for the final hole sizing. Thanks for everyone's input and suggestions. It's much appreciated.

 

[Stretch Joubert]

2012 S10 Dog bone drawing for */- 40 mm lift

 

[Stretch Joubert]

Note: The +/- 40 mm lift came from 110mm bolt center to bolt center dog bones( Lowered)