Search results

I'll take it. will send a PM.

@Defekticon What size tap did you end up using? I cannot find the size of the bolts my `13 uses.

As the title says, anyone know what the bolt size and thread pitch is? just need to know what tap size I need. I have a 2013 with Barkbusters and am looking to get new bars, but need the ends tapped or need to get inserts. Thank you!

This one, super awesome and great customer service

Oh I forgot to ask - Can you attach / detach the over the seat part wthout removing the main rack?

looks very nice, will be keeping an eye out for more pics and prices

Got mine on eBay for about 35 bucks I think. Put them in the other day, they look pretty good. I printed out my own bugger caps. Road the bike a few hours today and they seemed fine, was worried about the heat but I’m guessing they’ll be alright. Had them out last night in the dark, the pattern...

I bought the race tech bushings and the skf fork seal kits. Supposed to be higher quality and less stiction Can get you links if you want to what I ordered if you need it

Well, there was a coupon for those harbor freight lights so I grabbed two of them, at $20 each. They looks very similar to my rigid lights, and in fact plugged into the same pigtail plugs. They claim that the lights have Cree LEDs in them. I bought the flood version. Tried them in my benchtop...

Anyone tried any of the lights from harbor freight? Was just there and saw they were carrying led lights now.

Very cool. I will say your design is loads better than the very poorly designed Givi monokey setup my top box uses in conjunction with my altrider plate. There was like 1/4 play between the two, that you were supposed to take up with rubber bumpers. Riding off road those bumpers got squishe fat...

Very nice, just saw this. I had an altrider rack that cracked, have a steel copy of that now basically but since I am going to harbor freight later maybe I’ll see if they have a case that would fit under my rack. I have the bumot hard case and the racks have a tool box, keep some tools and...

Another thing to note, or at least make sure folks are aware of, is aftermarket seats. I have been looking into getting a seat concepts seat and noticed in some pics the rear seat is a bit wider and higher. Folks with an aftermarket rear seat might have a fit,net issue with you rack. Just...

I just did my forks - replaced the bushing, springs with Stoltec Moto, and seals with SKF. Like it quite a bit now, though I only got a little riding in.

Awesome, thanks for your responses, appreciate it! Mike

Ok I will measure, I eyeballed it and the seal looks the same thickness as the oem one, and the space is pretty thick. So my assumption is it is not needed. Hopefully someone else who has installed these seals can chime in too. In my searching I have not seen mention of extra spacers in thread...

Hello, My SKF fork seal kit came with a plastic spacer that had a notes that said basically use it for specific applications. Do I need to use it with the Tenere? It’s the little plastic ring in the picture. Thanks in advance, Mike

Thank you sir! Been thinking about it, especially after yesterday, rode 340 miles, more than 200 off road and the potholes and rocks started beating on my wrists a bit. Thanks again for the info! Mike

So I have about 400 miles on the AX41’s now, rode 340 miles today, a lot of it dirt. Have to say I like the tires quite a bit. Can lean way over on pavement and did not feel like they were walking, and in the muddy sections they seemed good. Only thing that seemed odd was the rear liked to go...

Yeah no worries I will just send them back and get the 385. I really tried to get them to fit, was pretty excited since I 3d printed some bigger caps for the headlights. There is no way the driver go in. Even pushing harder than I should. They are too long. And too fat, kinda like me.