Search results

I'm looking to upgrade the shock on my 2012. Anyone out there with something I'd be interested in?

Looking to upgrade the shock on my '12 S10. Anyone have an aftermarket shock for sale? Tks

hey 03A3KRH, Where is the Black Hill Nat Historic Trail? I plan to ride as much as I can during the rally and don't want to inadvertintly (sp?) tread on sacred ground without a permit. Leaving town for two weeks today if I don't respond to your reply..thanks in advance.

Well Done

Thanks Ladelsport, I will consider that prospect..

On the off chance that someone has a set of braided clutch/brake lines that they didn't install or are stripping from a sale bike I'd be interested. Cheers

Another essential bit of knowlege. Thanks gv550. I'll make sure they are the correct size.

Good to know, thanks again. Turns out that rocky mountain atv doesn't offer individual shims that are 9.5mm in dia., only 7.5mm. My local shop has a selection so I'll pick them up today. Three of the shims I have will slide over to diferent locations per your spread sheet so I'll only need to...

Help it did. Much simpler to use metric equivilents during calculations. Your spreadsheet with reserce percentage provided a good overview of what's going on up there in the top end. Finding shims available by the piece at rockymountainatv will make it easy to dial in the gaps near the "max...

Hi all. I'm doing my first valve adj (ok, late) at 36k on my '12 Tenere. I'm having trouble sorting out the numbers when it comes to inch/mm calculations for finding new shims to bring it into specs. If anyone can help it would be appreciated. cyl 1...

PM Sent

Thanks, that helps

Thanks all...I do have a low battery. I'll replace it and see what happens. I really appreciate your input.. Just cruised Hwy 89 south of Prescott, AZ. Out and back. Great twistie.

Started my '12 the other day and idle was normal. Mounted and rolled on the throttle and it stuck at around 3k. Checked that the throttle lock wasn't engaged and turned around. After a few hundred feet, braking and ready to hit the kill switch and the rpm's dropped to normal. First time for this...

Re: For Sale-AltRider crash bars Indianapolis I'll take them. zip code 85140

Excellent idea. I managed to remove the hinge pins, reach inside and unlock the case. Not the most secure cases on the market. But heh...

Just had my Loctited tumbler screws fall into the pannier along with the backing plate..wonderful to have a forum dedicated to our fantastic motorcycles!!

Looking to buy a set of AltRider crash bars for a 2012 S10. Preferably black but would take silver.

::015::Just pulled #4 fuse as described in the very first post of this Hard Start thread..held the throttle wide open and after a day of tinkering to find the problem it started right up..so happy

Having starting problems myself. I'll check the wiring harness...just a note though, my wife parks her car outside, in a field all summer while we spend winters in AZ. First year had mouse problems. Since then, four years now, we have been emptying a box of dryer sheets in every part of the car...