Search results

And you live in memphis???? Get a master macar catalog or grainger catolog.

Hope you have another saddle,Terry is booked out to may.

Nice,I also wanted a lift but D.R.V. said it would take to much weight off the pin (5th wheel)

The op wants a diesel pusher bus,so will be long allready.Wont be able to use small parks just with the bus.With the r.v. craze thats going on parks are getting bigger and used to full timers with there 44 foot 5er's and m.d.t.'s,diesel pusher buses and there trailers e.t.c..OP has allot of good...

I think if I was looking to tow a bike and a car id just get a enclosed car hauler,probably come out money ahead also compared to hydralift and tow bar setup.

Last time I checked hydralift was about $6,000.I think they post cost on new horizons build sheets.They have hydralifts as options for back of thier 5er"s.Some run swivelwheel trailers that are attached to tow vehicle in 2 places ,then hitch option to flat tow behind that.

Check out yama mama site on mt-03 teaser

They stock them at nielsen enterprises ,lake villa ill.its north central ill.Probably a full days ride from where your at.ph.#847-356-3000

1st valve clearance check done?

Thats an expensize housing.No way would i run with no caps.i.m.h.o.

Higher rpm downshifts tend to put more oil in breather.3.6 quarts for me ,2012 with 60k,never seen the oil light,change at 4k intervals.

Another note,if you put these on a tenere you will have a lot of extra wire harness, as harness has enough wire to reach batteries that are behind saddle.

That kit new comes with both lenses,yes they want you to wire to battery all wires and harness included with relay.Housings are aluminum.I just installed the larger 2.0 version. Spots for me were way farther out light than i needed.Put the floods in and very wide beam of light about half the...

Had the recall done.As long as they have to remove airbox, told them to sync throttle bodies now.Saved a lot of labor $$$.They claimed out of sync a little,runs much smoother.

Yamaha is known to set head bearings on the loose side,and if not checked and adjusted lower bearing gets damaged.With notch you feel my 2 cents is your lower bearing needs replacement.

Went to the chicago show last weekend.No ktm,ducati,aprilla ,moto guzzi,livewire.Just a very large picture of the tenere 700.Had fun,but wanted to see more.

Yes that gt looks like a great bike with nice features.My hooligan bike now is a 1999 kannon with a pro built 347 in it that i built from a kit in 1998 and titled in 1999. Having back and hip troubles now so i dont want to risk injury holding it up at stops.So the fj09 will replace that.s10...

Id like to buy a tracer gt,but for the money im going to get a left over fj09. Not the same bike for sure but 6k less.

Zero will release info on new bike the sr/f on 2-25-19. Supposed to be a naked bike.