Search results

  1. Trojan

    Starter Relay problem

    Same here, connections/terminals were great, bike is 3 years old, in a tropical country. But the starter relay failed after 13,000km. Upon "dissecting" the relay, it was found that the electromagnet and its coil remains good, but the main contacts were eroded due to arching. I ordered a genuine...
  2. Trojan

    Handlebar is grabbing to the right. I have to muscle it in order to run straight.

    Thanks a lot, this would be of big help for me, lots of pointers too.
  3. Trojan

    Handlebar is grabbing to the right. I have to muscle it in order to run straight.

    Hello! From Philippines XT1200Z 2018 made in The Netherlands By the way, I just got my bike back from YAMAHA servicing/troubleshooting. They did the a lot of fault finding for few days according to service manual (as attached). Recommended to change the tires again so I did. Brand new Pirelli...
  4. Trojan

    CrossPro Skid/Bash Plate??

    hello, Crosspro matte black installed on my ténéré. It's mounted (3bolts) n the oil pan. Thickness is about 3mm. Material: aluminum.
  5. Trojan

    Handlebar is grabbing to the right. I have to muscle it in order to run straight.

    At no-hander (cruise control mode), I need to lean further to the right side for the bike to run straight. Troubleshooting done: 1. Torque checking (Everything including the spokes). 2. Tires were replaced. 3. Removed the panniers and accessories. Symptoms persists
Top