Search results

  1. LostDonkey

    Before you strip to check your valves

    I drew very lucky this week. At 52k on the clock all indications were that my valves needed adjustment. So,I spent hours studying the topic on this forum and watching the YouTube video everyone pointed to preparing to spend at least 3 days in my theatre scrubs. Bloody thirsty work right, =...
  2. LostDonkey

    Driveshaft housing vent mod

    Hi all, I suspect this may be already out there but I could not find it so here goes. Last week the oil seal on the shaft side of the final drive starting leaking quite badly. On removing the pumpkin I was dismayed to find the lower half of the inside of the shaft housing full of grit and...
  3. LostDonkey

    Spot Light Bracket/Plate Template - Offer

    Hi all, I cut this template out of tin last year to test and then cut the final plate out of allu (I used an old bash plate from my previous, written off Ten). It fits under the headlight assembly and gets bolted to the four 'lugs' already there (part of the headlight frame sub). See photo's...
  4. LostDonkey

    Hi from Aus

    Hi all, new to forum but have been riding for many years. Currenlty on my second ST10, 2016 ES (60th Anniversary). First ST was 2010 G1, lost at 105k km's. Mods include 40mm lift, ECU re-map, slip-on exhaust, protective accessories and LED driving and spots. Also custom built dash for nav and...
Top